This Protocol is listed in the following Categories:
Isolation, purification and separation

Author(s): Chien-Sheng Chen and Heng Zhu
Lab/Group: Zhu lab
DOI: 10.1038/nprot.2007.544

High-throughput Hisx6-tagged protein purification

Chien-Sheng Chen, jason7@ntou.edu.tw, National Taiwan Ocean University

Heng Zhu, hzhu4@jhmi.edu, Johns Hopkins University

Lab/Group: Zhu lab

Journal: Nature Methods

Article Title: A proteome chip approach reveals new DNA damage recognition activities in Escherichia coli

Introduction

We have developed a high-throughput protein purification protocol that allows us to purify ~4,000 proteins within 10 hours from prepared culture. By combining steps of cell lysis and protein capture on affinity resins in sealed filter plates, we reduced the number of pipetting steps and thus, human errors.

Materials

Reagents

Equipment

Q-Fill2

Time Taken

10 hours

Procedure

1. Re-suspend cell pellets at 4 °C in 80 µL of lysis buffer, containing 50 mM NaH2PO4 at pH 8 with 300 mM NaCl, 20 mM imidazole, CelLytic B (Sigma), Lysozyme (1 mg/mL), Benzonase (50 units/mL), proteinase inhibitor cocktail (Sigma), and PMSF (1 mM/mL).
2. Wash Ni-NTA Superflow (QIAGEN) twice with water and twice with 50 mM NaH2PO4 at pH 8 with 300 mM NaCl, 20 mM imidazole using centrifugation.
3. Add 25 μL pre-washed Ni-NTA Superflow (QIAGEN) to each well
4. Transfer the mixtures into bottom-sealed filter plates (Multiscreen Nylon Mesh)
5. Seal the filter plates
6. Incubated for 1.5 hr at 4 °C with vigorously shaking
7. Remove seals
8. Wash the resin-protein complexes 3 times with 250 µL/well of wash buffer I (50 mM NaH2PO4 with 300 mM NaCl, 10% glycerol, 20 mM imidazole, 0.01% Triton X-100, at pH 8) and 3 times with Wash buffer II (50 mM NaH2PO4 with 150 mM NaCl, 25% glycerol, 20 mM imidazole, 0.01% Triton X-100, at pH 8) using a Q-fill2 (Gentix, UK).
9. Spin the filter plates
10. Add 25 μL of elution buffer (50 mM NaH2PO4/150 mM NaCl/25% glycerol/250 mM imidazole/0.01% Triton X-100, pH 7.5)
11. Incubate 15 min at 4 °C
12. Elute proteins into 96-well receiver plates by centrifugation.
13. Repeat 10-12
14. Store the proteins in 96-well plates at -80 °C

Troubleshooting

Critical Steps

Anticipated Results

References

Acknowledgements

This work is supported in part by the National Institute of Health (GM071440 to C.H.; U54 RR020839 to H.Z.), W. M. Keck Foundation (to C.H.), the Arnold and Mabel Beckman Foundation (to C.H.), and the Research Corporation (to C.H.).

Keywords

High-Throughput, Protein Purification

Post a comment


Extra navigation

Search Protocols

Feedback

0 comments have been posted on this protocol

ADVERTISEMENT